Filter
Top Products
STEP 10 (See Diagram 10 & Front Press Cable Loop Diagram)
A.) Attach one end of the 140” Front Press Cable (#48) to the bracket underneath the Right
Upper Frame (#1). Secure it with one M10 x 1” Allen Bolt (#94), two Ø ¾” Washers
(#100), and one M10 Aircraft Nut (#102).
B.) Draw the Cable to the opening on the Front Press Base (#2). Attach a Pulley (#67) to
the upper opening. Secure it with one M10 x 6 ¼” Allen Bolt (#88), two Ø ¾” Washers
(#100), and one M10 Aircraft Nut (#102).
C.) Draw the Cable around the Pulley to the opening on the Right Vertical Frame (#4).
Install a Pulley to the upper opening with M10 x 3 ½” Allen Bolt (#90), two Ø 7/8” x 1”
Pulley Bushings (#53), and one M10 Aircraft Nut (#102).
D.) Draw the Cable around the Pulley and back to the lower opening on the Front Press
Base. Repeat Procedure B above to install a Pulley.
E.) Draw the Cable around the Pulley to the lower opening on the Right Vertical Frame.
Repeat Procedure C above to install another Pulley.
F.) Draw the Cable underneath the Pulley then upward to the opening on the Right Upper
Frame (#1). Repeat Procedure C above to install a Pulley.
G.) Draw the Cable around the Pulley then downward. Attach a Pulley to the top hole on the
two Double Floating Pulley Brackets (#22).
H.) Secure the Pulley with one M10 x 1 ¾” Allen Bolt (#93), two Ø ¾” Washers (#100), and
one M10 Aircraft Nut (#102). Draw the Cable around the Pulley and upward. Let the
Brackets hanging for now.
I.) Draw the Cable upward to the open bracket underneath the Right Upper Frame. Repeat
Procedure H above to install a Pulley.
J.) Draw the Cable around the Pulley then downward in between the two Guide Rods to the
Selector Rod (#28). Fully thread the Bolt on the end of the Cable into the Selector Rod.
Use the Nut at the end of the Cable to tighten the Bolt.
18