Filter
Top Products
14
32. Insert three 45mm Square Inner Caps (88) into
the ends of the Leg Lever (70). Insert a 25mm
Round Inner Cap (87) into the weight tube on the
Leg Lever. Press a 25mm Angled Outer Cap (86)
onto the other end of the weight tube.
Attach the Leg Lever (70) to the Adjustable Bench
Leg (60) with an M10 x 70mm Bolt (91) and an
M10 Nylon Locknut (11). Note: Do not overtight-
en the M10 Nylon Locknut; the Leg Lever
must pivot easily.
33. Insert two 19mm Round Inner Caps (77) into the
ends of the three Pad Tubes (69).
Insert two Pad Tubes (69) through the holes in
the Leg Lever (70). Slide a Foam Pad (76) onto
each side of the Pad Tubes.
Insert a Pad Tube (69) through the upper tube on
the Adjustable Bench Leg (60). Slide a Foam Pad
(76) onto each side of the Pad Tube.
32
Weight
Tube
87
88
91
11
86
88
70
60
88
33
70
77
76
76
60
77
76
69
76
76
77
35. Make sure all parts are properly tightened
before you use the weight bench. The use of
the remaining parts will be explained in
ADJUSTMENTS on pages 15–17 of this manual.
34. Attach the Curl Pad (63) to the Curl Upright (64)
with two M6 x 16mm Screws (89).
34
89
64
63
31. Attach the Adjustable Bench Leg (60) to the
Bench Leg (59) with the Adjustment Knob (85).
Insert a 45mm Square Inner Cap (88) into the top
of the Adjustable Bench Leg (60).
31
59
60
88
85