Filter
Top Products
10
ASSEMBLY STEP 5
BOLT (G)
15 mm
Qty: 2
FLAT WASHER (J)
15 mm
Qty: 2
BOLT (K)
12 mm
Qty: 2
HARDWARE BAG 5 CONTENTS :
CONSOLE
CONSOLE MAST
BOLTS (G)
FLAT WASHERS (J)
BOLTS (K)
HANDLEBAR
HANDLERBAR BOOT
A Open HARDWARE BAG 5.
B Slide left HANDLEBAR to CONSOLE and
attach using 1 BOLT (K).
C Slide HANDLEBAR BOOT UP over bottom of
HANDLEBAR.
D Attach left HANDLEBAR to CONSOLE MAST
using 1 BOLT (G) and 1 FLAT WASHER J).
E Slide HANDLEBAR BOOT down to cover
HANDLEBAR-MAST conection.
F Repeat on other side.
G Connect power plug to the treadmill and
connect the cord to a power outlet. The on/
off switch is located next to the power cord.
Flip this switch to the ‘ON’ position, so that
the switch is lit. You will hear a beep and the
console will turn on.
H Before the first use, lubricate the treadmill deck by
following the instructions in the MAINTENANCE
section in the TREADMILL GUIDE.
ASSEMBLY COMPLETE!