Filter
Top Products
BEFORE
YOU BEGIN
14
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
15
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
4$3&8-
NN
2UZ
HARDWARE BAG FOR STEP 8 CONTENTS :
A S S E M B LY ST E P 8
LOWER HANDLEBAR
LOWER LINK ARM
INSIDE
ELBOW COVER
OUTSIDE
ELBOW COVER
SCREW (L)
A S S E M B LY ST E P 7
A ) Open HARDWARE BAG FOR STEP 7.
B) Align LOWER LINK ARM with U BRACKET.
CAUTION: Be careful to keep the LOWER LINK ARM aligned with guide rail. Do not twist it to the left or right
while positioning it on the U BRACKET.
C) Slide SPACER (F) through U BRACKET and FOOTPLATE TUBE.
D) Insert FLAT WASHER (C) and BOLT (G) into outside end of FOOTPLATE TUBE
E) Insert 2 SPLIT TEFLON WASHERS (E) on left and right sides of FOOT PLATE TUBE & Tighten Bolt (G).
F) Repeat on other side.
HARDWARE BAG FOR STEP 7 CONTENTS :
A) Open HARDWARE BAG FOR STEP 8.
B) Attach the OUTSIDE ELBOW COVER to elbow joint using 1 SCREW (L).
C) Snap the INSIDE ELBOW COVER onto the OUTSIDE ELBOW COVER.
Note the position of the snap tabs before snapping into position.
D) Repeat on other side.
LOWER LINK ARM
PEDAL ARMS
SPACER (F)
BOLT (G)
FLAT WASHER (C)
SPLIT TEFLON WASHER (E)
FOOTPLATE TUBE
TEFLON WASHER (E)
U BRACKET
BOLT (G)
FLAT WASHER (C)
FOOTPLATE TUBE
SPACER (F)
SPLIT
TEFLON WASHER (E)
U BRACKET
TOP VIEW OF LEFT FOOT PAD
INSERT
SPACER
THIS
DIRECTION
BOLT (G)
15 mm
Qty: 2
SPACER (F)
70 mm axis
Qty: 2
FLAT WASHER (C)
35 mm
Qty: 2
SPLIT TEFLON WASHER (E)
24 mm
Qty: 4
HZ_Ellipticals_Rev.1.5.indd 14-15 8/15/06 2:35:51 PM