Filter
Top Products
BEFORE
YOU BEGIN
8
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY ST E P 2
MAIN FRAME
CONSOLE WIRES
CONSOLE MAST
BOLT (A)
SPRING WASHER (B)
FLAT WASHER (C)
CONSOLE
MAST
BOOT
A) Open HARDWARE BAG FOR STEP 2.
B)
Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
C) Attach the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT
WASHERS (C).
BOLT (A)
20 mm
Qty: 4
SPRING WASHER (B)
18 mm
Qty: 4
FLAT WASHER (C)
20 mm
Qty: 4
SCREW (K)
10 mm
Qty: 2
EX-65 & EX-75 ONLY:
HARDWARE BAG FOR STEP 2 CONTENTS :
D) Insert the left TOP SIDE COVER, followed by the right TOP SIDE COVER and snap them together.
E) Insert ACCESSORY TRAY and secure it using 2 SCREWS (K) as shown (EX-65, EX-75 only).
F) Slide CONSOLE MAST BOOT down to seal the console mast hole.
SCREW (K)
10 mm
Qty: 2
EX-65 & EX-75 ONLY:
MAIN FRAME
CONSOLE
MAST
BOOT
TOP BACK COVER
SCREWS (K)
TOP SIDE COVERS
(EX-65, EX-75)
ACCESSORY TRAY
(EX-65, EX-75)
TOP FRONT COVER
EX-55 ONLY
A S S E M B LY ST E P 2 (CONTINUED)
HZ_Ellipticals_Rev.1.5.indd 8-9 8/15/06 2:35:43 PM