Filter
Top Products
27
Locate the Reed Switch (55) and the Magnet (54)
on the left side of the Pulley (53). Turn the Pulley
until the Magnet is aligned with the Reed Switch.
M
ake sure that the gap between the Magnet
and the Reed Switch is about 1/8 in. (3 mm). If
n
ecessary, loosen the #8 x 3/4" Tek Screw (80),
move the Reed Switch slightly, and then retighten
the Screw. Reattach the Motor Hood (not shown)
and run the treadmill for a few minutes to check for
a correct speed reading.
SYMPTOM: The incline of the treadmill does not
change correctly
a. Hold down the Stop button and the Speed increase
button, insert the key into the console, and then re-
lease the Stop button and the Speed increase but-
ton. Press the Stop button and then press the
Incline increase or decrease button. The treadmill
will automatically rise to the maximum incline level
and then return to the minimum level. This will recal-
ibrate the incline system. If the incline system does
not calibrate, press the Stop button, and then press
the Incline increase or decrease button again.
When the incline system is calibrated, remove the
key from the console.
SYMPTOM: The walking belt slows when walked on
a. Use only a single-outlet surge suppressor that
m
eets all of the specifications described on page 15.
b
. If the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both
idler roller screws counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
2 to 3 in. (5 to 7 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and run the
treadmill for a few minutes. Repeat until the walk-
ing belt is properly tightened.
c. If the walking belt still slows when walked on, see
the front cover of this manual.
Idler Roller Screws
2–3 in.
b
Top
View
54
1/8 in.
53
55
80