Filter
Top Products
9
42
9. Touch the Right Handrail (72) to discharge any static.
See the inset drawing. Slide the sleeve off the connec-
tor on the Upright Wire (42). Next, press the end of the
Upright Wire into the socket in the bottom of the Console
Base (47). The connectors should slide together eas-
ily and snap into place.
If they do not, turn one connec-
tor and try again. IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED ON. Then,
slide the sleeve back over the connector.
72
47
9
47
10. Set the Console Base (47) on the Handrails (71, 72).
Attach the Console Base with four 3/4" Screws (2). Start
all four Screws before tightening them; do not over-
tighten the Screws.
See the lower drawing. Make sure that the Upright
Wire (42) is routed below the two indicated round
posts (A). Next, press the Upright Wire into the slot be-
tween the square post (B) and the Console Base (47).
2
2
72
71
10
42
Sleeve
Connector
A
47
42
Small
Hole
71
8. With the help of a second person, hold the Console
Base (47) near the Left Handrail (71). Attach the end of
t
he ground wire to the indicated small hole in the Left
Handrail with the Silver Ground Screw (75).
47
75
G
round
W
ire
8
B