Filter
Top Products
11
11. Hold the handrail assembly near the console as-
sembly. Connect the wire harness extending
f
rom the console assembly to the wire harness
extending from the handrail assembly. See the
inset drawing in step 7. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
N
ECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON.
Set the Handrail Bracket (70) into the slot on the
console assembly as you slide the ends of the
Handrails (69, 71) onto the brackets on the
Uprights (77, 78). Be careful not to pinch any
wires.
69
70
77
78
Slot
Bracket
Console
Assembly
Handrail
Assembly
Bracket
11
12. Start two 1/4" x 1 1/2" Bolts (3) with 1/4"
Washers (31) and 1/4" Star Washers (11) into
the Console Frame (92) and Handrail Bracket
(not shown). Do not fully tighten the Bolts yet.
Start four 1/4" x 1/2" Bolts (6) with four 1/4" Star
Washers (11) into the lower end of the Handrails
(69, 71).
Press the lower end of the Handrails (69, 71)
against the Uprights (77, 78) as you tighten the
four 1/4" x 1/2" Bolts (6). Tighten the 1/4" x 1
1/2" Bolts (3).
6
3
69
71
78
77
92
11
12
71
6
11
Wire
H
arnesses
11
31
31