Filter
Top Products
22
Locate the Reed Switch (49) and the Magnet (37) on
the left side of the Pulley (38). Turn the Pulley until the
Magnet is aligned with the Reed Switch. Make sure
t
hat the gap between the Magnet and the Reed
Switch is about 1/8 in. (3 mm). If necessary, loosen
t
he #8 x 3/4" Clamp Screw (13), move the Reed
Switch slightly, and then retighten the Screw.
Reattach the Left Roller Cover (not shown) and run the
incline trainer for a few minutes to check for a correct
speed reading.
PROBLEM: The incline of the incline trainer does not change correctly
SOLUTION: a. Hold down the Stop button and the Speed increase button, insert the key into the console, and
then release the Stop button and the Speed increase button. Press the Stop button again. Then,
press the Incline increase or decrease button. The incline trainer will automatically rise to the
maximum incline level and then return to the minimum level. This will recalibrate the incline system.
If the incline does not calibrate, press the Stop button, and then press the Incline increase or de-
crease button again. When the incline is calibrated, remove the key from the console.
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 12.
b. If the walking belt is overtightened, incline trainer per-
formance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG THE
POWER CORD. Using the hex key, turn both idler
roller bolts counterclockwise, 1/4 of a turn. When the
walking belt is properly tightened, you should be able
to lift each edge of the walking belt 3 to 4 in. (8 to 10
cm) off the walking platform. Be careful to keep the
walking belt centered. Then, plug in the power cord,
insert the key, and run the incline trainer for a few
minutes. Repeat until the walking belt is properly
tightened.
c. If the walking belt still slows when walked on, please see the front cover of this manual.
38
1/8 in.
37
3–4 in.
b
Idler Roller Bolts
T
op
View
49
13