Filter
Top Products
10
8. Have a second person hold the Console (84)
near the Yoke (88).
Connect the Upright Wire (72), the Left and
Right Pulse Wires (70, 71), and the Console
Ground Wire (89) to the wires extending from
the Console. See the inset drawing. The con-
nectors should slide together easily and
snap into place. If they do not, turn one con-
nector and try again. IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Insert the excess wire into the Console (84).
8
84
89
71
72
70
72
88
Console
Wires
Console Wire
7. Slide the Accessory Tray (86) onto the Yoke
(88). Partially insert the two indicated tabs and
then partially insert the other tabs. Then, fully in-
s
ert all of the tabs. Be careful not to break the
tabs.
Attach the Accessory Tray (86) to the Yoke (88)
with four #8 x 3/4" Screws (1). Start all four
Screws before tightening any of them. Do
not overtighten the Screws.
7
8
6
Tabs
1
1
88