Filter
Top Products
11
10
12
74
73
10. Attach the Console Cover (73) to the top of the
Upright (74) with two #8 x 1/2" Screws (12). Do
not overtighten the Screws.
11. Make sure that all parts are properly tightened before you use the incline trainer. If there are sheets of
clear plastic on the incline trainer decals, remove the plastic. To protect the floor or carpet, place a mat under
the incline trainer. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one
of the hex keys is used to adjust the walking belt (see pages 22 and 23).
9. Attach the Console (84) to the plate on the Yoke
(88) with four #8 x 3/4" Screws (1). Be careful
not to pinch any wires. Start all four Screws
b
efore tightening any of them. Do not over-
tighten the Screws.
9
1
1
88
8
4