Filter
Top Products
21
TROUBLESHOOTING
Most incline trainer problems can be solved by following the steps below. Find the symptom that applies,
a
nd follow the steps listed. If further assistance is needed, please see the front cover of this manual.
PROBLEM: The power does not turn on
S
OLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 12). Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 12. IMPORTANT: The incline trainer is
not compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
c. Check the reset/off circuit breaker located on the in-
cline trainer frame near the power cord. If the switch
protrudes as shown, the circuit breaker has tripped.
To reset the circuit breaker, wait for five minutes and
then press the switch to the reset position.
PROBLEM: The power turns off during use
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait
for five minutes and then press the switch to the reset position.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the incline trainer still will not run, please see the front cover of this manual.
PROBLEM: The console displays remain lit when you remove the key from the console
SOLUTION: a. The console features a display demo mode, designed to be used if the incline trainer is displayed
in a store. If the displays remain lit when you remove the key and the incline rises to the maxi-
mum level, the demo mode is turned on. To turn off the demo mode, hold down the Stop button
for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 19 to turn
off the demo mode.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE
POWER CORD. Remove the three indicated #8 x 1/2"
Screws (12). Lift off the Left Roller Cover (35).
Tripped Reset
c
12
12
a
35