Filter
Top Products
18
28. Wrap the Lat Cable (49) around a 90mm Pulley
(48) and route the Cable down through the Top
Frame (4). Attach the Pulley inside the Top Frame
with an M10 x 80mm Bolt (84), two M10 Washers
(80), two 19mm Spacers (67), and an M10 Nylon
Locknut (77).
29. Set an M12 Large Washer (98) on top of the
Weight Tube (20). Thread the M12 Nut (112) all
the way onto the Lat Cable (49).
Thread the Lat Cable (49) into the Weight Tube
(20) two turns. Tighten the M12 Nut (112)
against the M12 Large Washer (98).
30. Identify the Leg Lever Cable (51). Route the
Cable through the Leg Lever (12) and the Front
Leg (10).
Insert a 90mm Pulley (48) into the Leg Lever (12)
from behind as shown. Attach the Pulley with an
M10 x 65mm Bolt (85), two M10 Washers (80),
two 13mm Steel Spacers (109), and an M10
Nylon Locknut (77).
28
29
112
98
20
49
80
80
77
48
4
49
67
67
84
30
85
80
12
109
51
77
109
80
48
10