Filter
Top Products
30
FIGURE 14
Step 80.
Step 81.
Step 82.
Step 83.
Step 84.
Step 85.
Step 86.
Step 87.
Attach two PULLEYS (76) to DOUBLE BRACKET on RIGHT BENCH PRESS FRAME (20) and
DOUBLE BRACKET on RIGHT OBLIQUE FRAME (2) with 3/8” x 3-1/2” HEX BOLTS (56), 3/8”
WASHERS (62) and 3/8” LOCKNUTS (67).
Insert PULLEY (76) into SLOT of RIGHT OBLIQUE FRAME (2) and LEG EXTENSION FRAME
(14) and fasten with 3/8” x 2-5/8” HEX BOLTS (53), 3/8” WASHERS (62), 13mm BUSHINGS (46)
and 3/8” LOCKNUTS (67).
Attach a PULLEY (76) to five SINGLE BRACKETS with 3/8” x 2” HEX BOLT (51), 3/8” WASH-
ERS (62) and 3/8” LOCKNUT (67).
Attach a PULLEY (76) to one side of DOUBLE PULLEY BRACKET “A” (39) and one side of
DOUBLE PULLEY BRACKET “B” (40) with 3/8” x 2” HEX BOLT (51), 3/8” WASHERS (62) and 3/
8” LOCKNUT (67).
Insert EYE END of LEG CABLE (94) under PULLEY (76) in LEG EXTENSION FRAME (14), and
then insert around all remaining PULLEYS as shown in FIGURE 14 and DETAIL. Follow the cable
route starting at position “A” and ending with position “N”.
Attach CHAIN (91) to end of LEG CABLE (94) with CHAIN HOOK (90).
Attach other end of CHAIN (91) to PRESS CABLE (55) with CHAIN HOOK (90).
NOTE: The CHAIN is used to remove large amounts of slack in cable. The HEFT CABLE AD-
JUSTER is used to remove small amounts of slack.
Make sure LEG CABLE (94) is riding in groove of PULLEYS (76).