Filter
Top Products
20
FIGURE 8
Step 36.
Step 37.
Step 38.
Step 39.
Step 40.
Step 41.
Step 42.
Attach RIGHT BACKREST CUSHION (31) to RIGHT OBLIQUE FRAME (2) with 3/8” x 2-5/8”
HEX BOLTS (53) and 3/8” WASHERS (62).
Push 3/4” BUSHINGS (70) into RIGHT BENCH PRESS FRAME (20).
Attach PULLEY (76) to RIGHT BENCH PRESS FRAME (20) with 3/8” x 6-1/8” HEX BOLT (59), 3/
8” WASHERS (62) and 3/8” LOCKNUT (67).
Attach RIGHT BENCH PRESS FRAME (20) to RIGHT BASE BEAM (1) with 5/8” x 7-3/4” SHAFT
BAR (61), 5/8” WASHERS (65) and 5/8” LOCKNUTS (66).
Attach RIGHT PRESS ARM (19) to RIGHT BENCH PRESS FRAME (20) with 3/8” x 3” HEX
BOLTS (54), 3/8” WASHERS (62) and 3/8” LOCKNUTS (67).
Push 1” ROUND END PLUGS (74) into ends of RIGHT PRESS ARM (19) and slide 2” SQUARE
END CAPS (72) over ends.
NOTE: Liquid soap applied to RIGHT PRESS ARM (19) will help LONG FOAM GRIPS (84) slide
on easier.
Slide LONG FOAM GRIPS onto ends of RIGHT PRESS ARM (19) until flush with end.