Filter
Top Products
24
FIGURE 10
Step 50.
Step 51.
Step 52.
Step 53.
Step 54.
Step 55.
Step 56.
Step 57.
Step 58.
Step 59.
Step 60.
Step 61.
Attach PIVOT PULLEY BRACKETS (32) to RIGHT OBLIQUE FRAME (2) with M8 x 63mm HEX
BOLTS (52), M8 WASHERS (64) and M8 LOCKNUTS (69).
Attach PULLEYS (76) to PIVOT PULLEY BRACKETS (32) with 3/8” x 2” HEX BOLTS (51), 3/8”
WASHERS (62) and 3/8” LOCKNUTS (67).
NOTE: Do not overtighten. PULLEYS must rotate freely.
Push 2” SQUARE END PLUGS (71) into ends of BUTTERFLY EXTENSION (25) and attach to
RIGHT OBLIQUE FRAME (2) with 3/8” x 3-1/2” HEX BOLTS (56), 3/8” WASHERS (62) and 3/8”
LOCKNUTS (67).
Push 3/4” BUSHINGS (70) into BUTTERFLY EXTENSION (25) and ADJUSTABLE PLATES (27
RIGHT and 29 LEFT).
Insert RIGHT BUTTERFLY ARM (28) through RIGHT ADJUSTABLE PLATE (27), BUTTERFLY
EXTENSION (25) and fasten with 5/8” WASHER (65) and 5/8” LOCKNUT (66).
NOTE: Do not overtighten. RIGHT BUTTERFLY ARM must pivot freely.
Insert LEFT BUTTERFLY ARM (30) through LEFT ADJUSTABLE PLATE (29), BUTTERFLY EX-
TENSION (25) and fasten with 5/8” WASHER (65) and 5/8” LOCKNUT (66).
NOTE: Do not overtighten. LEFT BUTTERFLY ARM must pivot freely.
NOTE: Liquid soap applied to HANDLES (26) will help HAND GRIPS (86) slide on easier.
Slide HAND GRIPS onto HANDLES.
Push 1” ROUND END PLUG (74) into HANDLES (26).
Push PLASTIC BUSHINGS “A” (87) into BUTTERFLY ARMS (28 RIGHT and 30 LEFT).
Insert HANDLES (26) through PLASTIC BUSHINGS “A” (87) and fasten with M8 x 25mm HEX
BOLT (48) and 3/8” BIG WASHER (63) and 5/8” WASHER (65).
Push 2” ROUND END PLUG (75) into end of BUTTERFLY ARMS (28 RIGHT and 30 LEFT).
Use POP PIN (89) in BUTTERFLY ARMS (28 RIGHT and 30 LEFT) to select desired hole in
ADJUSTABLE PLATES (27 RIGHT and 29 LEFT).