Filter
Top Products
Step 1:
Only hand tighten fasteners for now.
You will be prompted to fully tighten
all fasteners later.
Place the Base Frame (1) on the floor.
Cap the Base Frame (1) with the 2" X 3"
Rect End Plug (42). Cap the Rear
Stabilizer (2) with two 1-3/8” x 3” Rect End
Caps (41). Attach the Rear Stabilizer (2)
to the Base Frame (1) using two 1/2" x 3"
Hex Head Bolts (62), six 1/2" Washers
(74) and four 1/2" Nylon Nuts (76) as
shown in FIG 1.
Cap the Upright (3) with the 2" x 3" Rect
End Plug (42). Attach the Bumper (45) to
the horizontal tube on the Upright (3).
Attach the Pop Pin (56) to the Upright (3).
Attach the Stopper (48) to the Upright (3)
using the 3/8” x 3/4” Sunken Head Screw
(72) as shown in FIG 2.
Attach the Upright (3) to the Base Frame
(1) using two 1/2" x 3" Hex Head Bolts
(62), four 1/2" Washers (74) and two 1/2"
Nylon Nuts (76) as shown in FIG 3.
assembly instructions
-8-
ASSEMBLY
FIG-3
FIG-1
FIG-2