Filter
Top Products
Step 6:
Cap the Press Support (14) with two 2"
Sq End Plugs (43). Attach two Pop Pins
(57) to the Press Support (14). Attach
the Press Support (14) to the Top Frame
(9) using the 1/2" x 7-1/4" Hex Head
Bolt (59) and a 1/2" Nylon Nut (76) as
shown in FIG 13.
Slide the 1-1/4" Hand Grips (28) onto
the Handle Bars (15). If the Hand Grips
(28) are difficult to slide onto the Handle
Bars (15) try applying a small amount
of soapy water to the Handle Bars (15)
prior to sliding on the grips. Attach the
Handle Bars (15) to the Press Support
(14) using one 3/8" x 2-3/4" Hex Head
Bolt (66), one 3/8" x 3" Hex Head Bolt
(65), four 3/8" Washers (75) and two
3/8" Nylon Nuts (77) for each as shown
in FIG 14.
ASSEMBLY
assembly instructions
-13-
FIG-13
FIG-14