Filter
Top Products
assembly instructions
-17-
Step 10:
Cap the Adj Seat Arm (20) with two 2"
Sq End Plugs (43). Slide the 1" Hand
Grips (30) onto the Seat Handle Bars
(21). Attach the Seat Handle Bars (21)
to the Adj Seat Arm (20) using two 3/8"
x 3" Hex Head Bolts (65), four 3/8"
Washers (75) and two 3/8" Nylon Nuts
(77). Attach the Seat Pad (25) to the
Adj Seat Arm (20) using two 3/8" x 2-
1/2" Hex Head Bolts (70) and two 3/8"
Washers (75) as shown in FIG 16.
Insert the Adj Seat Arm (20) into the
Seat Support (18) and lock with the
Quick Release (55). Insert the Bolster
(12) into the sleeve (welded on the Adj
Seat Arm) and secure with a 5/16"
Sunken Head Screw (78). Slide a 4"
Foam Pad (27) onto each end of the
Bolster (12) as shown in FIG 17. If the
Foam Pads (27) are difficult to slide onto
the Bolster (12) try applying a small
amount of soapy water to the Bolster
(12) prior to sliding on the pads. Cap
each end of the Bolster (12) with a 1"
End Plug (44).
Firmly tighten all bolts at this time.
ASSEMBLY
FIG-17
FIG-16