Filter
Top Products
Stabilizer adjustment instruction:
An uneven floor or improper stabilizer level can
cause the treadmill to wobble during use as
well as the incline adjustment to function
incorrectly. Please follow the procedure
described below to make sure the treadmill
stabilizer is adjusted correctly prior to use. You
may need the assistance of another person to
perform this adjustment.
1. To perform the stabilizer adjustment you
first need to bring the treadmill to the highest
incline level as shown in figure A. After you’ve
completed the assembly procedure plug in the
power cord and switch on the POWER
SWITCH. Insert the Safety Key and press the
START button to quick start the treadmill. Press
the INCLINE UP button until Level 12 shows
on the console. This is the highest incline level.
Now press the STOP button and pull out the
Safety Key. Switch off the POWER SWITCH
and unplug the power cord.
2. Inspect the four stabilizers (two per side)
located underneath the base frame. The
treadmill should sit on the floor with all 4
stabilizers resting firmly on the floor as shown
in figure B. Shake the handlebars back and
forth to check if they are resting firmly on the
floor. If they are not, pull the handlebar
backward to adjust the two front stabilizers and
push the handlebar forward to adjust the two
rear stabilizers as shown in figure C. Simply
turn the stabilizers like a screw to adjust their
heights. Repeat this until all 4 stabilizers sit
firmly on the floor.
STABILIZER ADJUSTMENT
stabilizer adjustment
Bring the treadmill to the
highest incline level.
Check to make sure the stabilizers
are resting firmly on the floor.
Pull the handlebar
backward or forward to
access the stabilizers.
A
B
C
-29-