Filter
Top Products
9
6. Place the treadmill in the storage position (see HOW TO
FOLD AND MOVE THE TREADMILL on page 24).
Next, place the cylinder end of the Gas Spring (92) near
the bracket on the base of the Uprights (84).
See the two small inset drawings. Using your fingernail
or the end of a screwdriver, press on the end of the
Spring Pin (25) to loosen it from the Gas Spring (92).
Next, rotate the Spring Pin and pull it out of the Gas
Spring. Be careful to avoid losing the Spring Pin.
Note: Extra Spring Pins are included.
See drawing 5a. Press the cylinder end of the Gas
Spring (92) onto the ball on the bracket. Next, insert the
end of the Spring Pin (25) into two of the small holes in
the end of the Gas Spring. Then, rotate the Spring Pin
until it clips onto the Gas Spring.
92
25
92
25
6
5a
84
Bracket
Cylinder
Bracket
25
25
7. Raise the Gas Spring (92) to a vertical position. Remove
the Spring Pin (25) from the raised end of the Gas Spring
as described in step 6. If necessary, rotate the Gas
Spring to align the end of the Gas Spring with the ball on
the bracket on the Frame (58).
Next, press the Incline increase and decrease buttons on
the console until the ball on the bracket is aligned with
the end of the Gas Spring (92). Then, press the end of
the Gas Spring onto the ball. Note: It may be necessary
to press the end of the Gas Spring onto the ball while the
Frame (58) is moving.
See drawing 7a. Insert the Spring Pin (25) into the two
indicated small holes in the end of the Gas Spring (92).
Then, rotate the Spring Pin until it clips onto the Gas
Spring.
Press the Incline decrease button until the treadmill
is at the lowest incline level. Then, unplug the power
cord.
25
92
Holes
25
92
7
7a
58
Bracket
5
. Press the Latch Housing (73) into the left Upright (84).
Use a rubber mallet, if necessary, to fully insert the Latch
Housing.
R
emove the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are two col-
lars, place one on each side of the spring.) Next, insert
the pin into the Latch Housing (73). Then, tighten the
knob back onto the pin.
Plug in the power cord as described on page 12, and
turn on the power as described on page 14. Note: The
treadmill may automatically rise to the maximum incline
level and then return to the minimum level.
Pin
Spring
C
ollar
Knob
73
5
84