Filter
Top Products
3
ENG
3
4
5
Brake button
Front leg
(with casters)
Nut
Flat washer
Nut
Rear legs
(level adjustment screw)
Front and rear leg
installation screws
Steering post
Steering post
adjustment lever
Cable
connector
Stopper screw
Steering unit
Flat washer
Steering unit
installation screw
M5 screw
Controller bracket
Steering installation bracket
Steering unit
Steering
M6 cap bolt
Controller
Bracket
Flat washer
Installation bolt
7
11
9
1
12
2
6
10
How to assemble GBF PRO RECUMBENT BIKE (1)
Follow the procedure below to assemble the product.
3
Installing the steering unit
• Insert the steering unit in the steering post and securely tighten
the “steering unit installation screw set” (4 screws).
1
Installing the front and rear legs
• Use the “front and rear leg installation screw set” (4 each of screws
and washers) to securely install the front legs (with casters) to the
front of the main unit (steering post side).
• In the same way, install the rear legs onto the rear of the main unit.
2
Installing the steering post
• Attach the two connectors on the steering post to the two connec-
tors on the main unit.
• Turn the steering post adjustment lever counterclockwise to loosen
it and then insert the steering post into the frame of the main unit.
Caution When inserting the steering post into the frame of
the main unit, be careful not to pinch the cable
inside the pipe against the post.
• Raise the steering post to the mark and then secure the post using
the steering post adjustment lever.
• Align the hole of the steering post with that on the side of the
frame pipe, install and tighten the stopper screw.
5
Installing the steering assembly and controller
• Remove the M6 cap bolts which fasten the steering installation
bracket to the steering unit.
• Install the steering, and securely fasten the steering installation
bracket and controller using the bolts which were previously re-
moved.
Important Install the steering so that the steering assembly is
perpendicular to the steering unit.
6
Installing the bracket
• Install the bracket on the steering unit. Insert the bracket from
underneath the steering unit and securely fasten the bracket using
the supplied bolt.
Important Install the bracket so that the bracket is perpen-
dicular to the steering unit.
4
Installing the controller bracket
• Remove the M5 screws (X4) from the back of the controller unit.
• Secure the controller bracket to the controller with the removed
M5 screws.
Diagram showing com-
pleted assembly