Filter
Top Products
6
1. Level Adjustment
• Turn the level adjuster on the rear leg so that the unit is
placed stably.
• When the indication line on the level adjuster is at the
top, the rear leg is at the same level as the caster of the
front leg.
2. Adjusting Seat Position
The seat position can be adjusted while pulling up the seat
lock pin. When desired seat position is obtained, release
the lock pin free and move the seat slightly and the lock pin
will click into the nearest hole by spring pressure. Holes
are provided at an interval of 3 cm(1-3/16").
Note: When sliding the seat, take care not to break the
pulse sensor cable.
EC-35OO
ADJUSTMENT
Make each adjustment under the following process.
2
5
3
4
Fig. 1
Fig. 2
1
3
7
8
6
4
2
5
3 cm(1-3/16")
PULL
lock pin
indication line
level adjuster
1
cable holders
7
4. Adjusting Pedal Belts
It is possible to adjust the pedal belt length according to
your shoes size.
3. Adjusting Seat Height
• The seat height can be adjusted at your choice.
• The higher the seat, the less intense the exercise or vice
versa.
• Loosen and remove the seat height lock knob, supporting
the seat pipe with the other hand.
• Move up or down the seat pipe to the desired height and
screw-in the seat height lock knob. While tightening the
knob lift the seat pipe slightly for easier screwing. Holes
are provided at an interval of 3 cm(1-3/16").
Ideal exercise posture
5. Mounting Pulse Sensor
• Insert the pulse sensor plug into the pulse sensor jack at
the side of the control panel.
• Attach the cable holders at the main frame and the seat
pipe. (Upper figure on page 6)
• Insert the sensor cable through the cable hooks and cable
holders. Hold the cable in position by attaching the sen-
sor clip at the bend of the handlebar. (Fig. 4)
• Allow enough slack in cable under the seat pipe for seat
adjustment.
• Attach the cable clip to your clothes during exercise to
avoid excessive swinging of the sensor cable.
• Attach the pulse sensor on the sensor clip when not in
use.
seat height
lock knob
• Adjust the seat position as illustrated. Find the position
where your knee is slightly bent when the pedal is at the
farthest position.
sensor clip
cable hooks
cable clip
pulse sensor
cable holders
pulse sensor plug
pulse sensor jack
Fig. 4
seat height
lock knob
Fig. 3
EC-35OO
casters
• When moving the
main unit, lift the rear
frame holding by the
seat height lock knob,
and roll the casters.