Filter
Top Products
Using the Crown
The watch’s crown is a screw-in (screw
lock) type. To use the crown, you first
need to rotate it towards you (leftwards)
to loosen it.
Loosen
Crown
Important!
●
To prevent loss of water
resistance and/or damage due
to impact, be sure to push the
crown in and lock it when not in
use.
●
When pushing the crown back
in, take care not to apply too
much force.
●
Fast Forward/Fast Reverse
After pulling out the crown, rotating it
quickly in succession in either direction
will start a fast forward or fast reverse
operation.
While a
fast forward operation
is in progress, quickly rotating the crown
in succession again will increase the
speed even further.
●
The fast reverse operation speed is
fixed and cannot be changed.
●
Stopping Fast Forward/Fast
Reverse
Rotate the crown in the direction
opposite
that of
the ongoing operation or
press any button.
Note
●
If you do not perform any
operation for about
two minutes
after pulling out the crown,
crown operations will
automatically become disabled.
If that happens, push the crown
back in and then pull it out again.
Changing Hand and the Day
Indicator Settings
●
Mode Hand and Day Indicator
Movement
Changing the day setting of the watch will
also cause the mode hand to move.
●
Day
●
It can take anywhere from about 90
seconds to three minutes for the day
indicator to change after timekeeping
reaches midnight. The mode hand
moves as the day indicator changes.
●
The
day
may
not be indicated correctly
while the watch’s crown is pulled out.
Day indicator
Mode hand
Solar Charging
What is solar charging?
This watch runs on power supplied from
a rechargeable (secondary) battery that
is charged by a solar panel. The solar
panel is integrated into the face of the
watch, and power is generated
whenever the face is exposed to light.
Charging the Watch
When you are not wearing the watch, put
it in a location where it is exposed to
bright light.
While you are wearing the watch, make
sure that its face (solar panel) is not
blocked from the light by the sleeve of
your clothing. Power generation
efficiency is reduced
even when the face
of the watch is blocked only partially.
NOYES
Important!
●
Depending
on
light
intensity and
local conditions, the watch may
become hot to the touch when
exposed to light for charging.
Take care to avoid burn injury
after charging. Also, avoid
charging the watch under high-
temperature conditions like the
ones described below.
ー
On the dashboard of a vehicle
parked in the sun
ー
Near an incandescent light
bulb or other source of heat
ー
Under direct sunlight or in
other hot areas for long
periods
Operation Guide 5419
2