Filter
Top Products
23
Bowflex® TreadClimber® Assembly and Owner’s Manual
Remote Heart Monitor
Monitoring your Heart Rate is one of the best ways to control the intensity of your exercise.
This feature is built into the TC5300/TC6000.
The TC5300/TC6000 uses a Heart Rate Chest Strap Transmitter to send your Heart Rate
signals to the console. The console displays your Heart Rate in “beats per minute’ in the
lower-middle window of the display.
The Heart Rate Chest Strap Transmitter is included. It is a Polar® model T34. The battery in
the T34 is not replaceable.
HOW TO USE YOUR CHEST STRAP
Using the Bowflex® TreadClimber® fitness machine heart rate transmitter chest strap, you can monitor your heart rate
at any time during your workout:
5. The transmitter will send your heart rate to the TreadClimbe
r® fitness machine’s receiver and your Beats Per
Minute (BPM) will be displayed in the HEART RATE display within a matter of several seconds.
6. Always remove the transmitter before cleaning the chest strap. Clean the chest strap regularly with mild soap
and water and thoroughly dry it. Residual sweat and moisture keep the transmitter active and drain the battery
in the transmitter.
NOTE: Do not use abrasives or chemicals such as steel wool or alcohol for cleaning, as they can
damage the electrodes permanently.
Replacement chest straps are available by calling your TreadClimber® Representative.
If the Heart Rate Transmitter is not sending a signal to your console, the PULSE display will show 3 dashes. Check to
make certain that the textured contact areas on the chest strap are contacting with your skin. You may need to lightly
wet the contact areas. If no signal appears or you need further information, please call a TreadClimber® Representative.
1. The heart rate
transmitter is
attached to a chest
strap to keep your
hands free during
your workout.
Attach the transmitter
to the elastic chest
strap.
2. Adjust the strap
length to fit snugly
and comfortably
against your
skin. Secure the
strap around your
chest, just below
the chest muscles,
and buckle it.
3. Lift the transmitter
off your chest and
moisten the two
grooved electrode
areas on the back.
4. Check that the
wet electrode areas
are firmly against
your skin.
HEART RATE MONITORING