Filter
Top Products
Owner’s Manual
17
Walking Belt Adjustment
If either of the walking belts seem to be tracking excessively to one side or the other, adjustments can be made at the
front roller of each treadle.
Misalignment Test and Resolution
on each end of each front roller. If the belt is tracking too far to the right, turn clockwise to tighten the right adjustment bolt
on that roller using the provided hex key in full turn increments to realign belt. If the belt seems to be tracking too far to the
left, do the same thing on the left adjustment bolt for that roller.
Check belt tension:
The belts should be just tight enough that your fingers laid flat can fit snugly under the belt at it’s mid-point. If a belt is not
snug turn both knobs clockwise one full turn and check tension again. Repeat this step if necessary.
If a belt is too tight, loosen (turn counter-clockwise) the bolt adjustment knobs one full turn and re-check the tension.
Repeat this step until fingers can fit snugly under the belt.
Note:
when adjusting belt alignment.
Getting Started
Walking Belt Alignment
Exploded View
Adjustment
Bolts
Adjustment
Bolts