Filter
Top Products
Owner’s Manual
13
Remote Heart Module (TC5000 Only)
The Remote Heart Module and Heart Rate Transmitter are features on the TC5000 only.
You may use the TC5000 Heart Rate Transmitter or any other Heart Rate Transmitter that is
compatible with the
TreadClimber
®
TC5000 to help keep yourself within your target fat-burning
heart rate zone during your workout.
Note: A Heart Rate Strap with a non-replaceable battery is included. It will work with Polar
®
watches. To promote contact it should be wet with perspiration, gel or saliva. To promote
maximum life, it must be rinsed with clean water and dried after each use. A one year life
is expected, replacement part T41 is available from Polar
®
or Nautilus, Inc.
How to Use Your Chest Strap: Using the Bowflex
®
TreadClimber
®
heart rate transmitter chest strap, you can monitor your
heart rate at any time during your workout
5. The transmitter will send your heart rate to the TreadClimber
®
machine’s receiver and your Beats Per Minute (BPM)
will be displayed in the HEART RATE display within a matter of several seconds.
6. Always remove the transmitter before cleaning the chest strap. Clean the chest strap regularly with mild soap and
water and thoroughly dry it. Residual sweat and moisture keep the transmitter active and drain the battery in the
transmitter.
Note:
permanently.
Replacement chest straps are available by calling your TreadClimber
®
NOTICE: Never immerse the Heart Rate Transmitter in water—doing so could permanently damage the
monitor and cause it to malfunction.
If the Heart Rate Transmitter is not sending a signal to your console, check to make certain that the metal electrodes on
the chest strap are connecting with your skin. You may need to lightly wet the circles so
they adhere.
If no signal appears or you need further information, please call a TreadClimber
®
Representative
1. The heart rate
transmitter is
attached to a chest
strap to keep your
hands free during
your workout.
Attach the transmitter
to the elastic chest
strap.
2. Adjust the strap
length to fit snugly
and comfortably
against your skin.
Secure the strap
around your chest,
just below the
chest muscles,
and buckle it.
off your chest and
moisten the two
grooved electrode
areas on the back.
4. Check that the
wet electrode areas
are firmly against
your skin.
Getting Started