Filter
Top Products
61200275L1-1 TSU IQ+ User Manual 7-1
Chapter 7
Configuring the Network Port
NETWORK PORT
Access the N
ETWORK
P
ORT
menus by selecting N
ETWORK
P
ORT
from the C
ONFIGURATION
menu. Full menu trees for the N
ETWORK
C
ONFIGURATION
selections are shown in Figure 5-2 on page 5-3
(Terminal Configuration Menu Tree) and Figure 5-3 on page 5-4
(Front Panel Configuration Menu Tree). The
Network
P
ORT
terminates the user end of the frame relay UNI interface. The
TSU IQ+ supports three standard PVC signaling formats: LMI
(gang of four), ANSI T1.617-D (Annex D), and ITU Q.933-A (Annex
A). The selected signaling format is used to poll the network end of
the UNI interface and retrieve virtual circuit information.
Optionally, the polling process can be disabled.
When configuring from a terminal, the screen in Figure 7-1 on page
7-2 will appear when N
ETWORK
P
ORT
is selected.
In this chapter, the terminal selections are listed first followed by the front
panel selections in parentheses (if the names differ).