Filter
Top Products
Chapter 4. Applications
4-4 TSU IQ+ User Manual 61200275L1-1
Minimum Configuration Requirements
The following options (all found in the S
YSTEM
portion of the
C
ONFIGURATION
menu) are the minimum configuration
requirements for establishing out-of-band SNMP or Telnet access.
Oncetheseoptionsareconfigured,theunitmaybeaccessedusing
SNMP/Telnet.
IP Address
Enter the TSU IQ+ IP address.
Control Port Options
If necessary, select SLIP or PPP as the TSU IQ+ C
ONTROL
P
ORT
O
PTIONS
. If the ethernet card is the interface type, this parameter
does not affect setup. This selection is found in the S
YSTEM
portion
of the C
ONFIGURATION
menu.
Subnet Mask
Enter the subnet mask number assigned to the network formed by
the TSU IQ+ and the other FRAD/routers across the frame relay
network. This address is available from the network administrator
and is only necessary when using the ethernet card.
Gateway IP Address (if required)
Enter the Gateway node IP address. This address is applicable only
if the TSU IQ+ and the network manager are connected through a
Gateway node. This address is available from the network
administrator and is only necessary when using the ethernet card.
The next five settings are applicable for SNMP access only.
Read Community
Set the R
EAD
C
OMMUNITY
name to match the NMS (network
management system) settings.
Write Community
Set the W
RITE
C
OMMUNITY
name to match the NMS settings.
Trap Manager DLCI
Identify the virtual circuit used for all traps generated by the TSU
IQ+. This selection is found in the S
YSTEM
portion of the
C
ONFIGURATION
menu.