Filter
Top Products
Sec1:4-Sec1:5
4 5
SETTING UP YOUR PEDOMETER
ACCUSPLIT products use a common setting procedure, S1-
S2-S3-S4.
Press S1 for 2 seconds: Enter the SET mode
Press S2: Change the fi eld to be set
Press S3: Change the fi eld value
Press S4 for 2 seconds: Exit the SET mode
Setting the Clock
The clock must be set in order for the memory’s automatic
rollover function to work correctly.
Mile/h
2.04 5:18
8722
Clock
Speed
STEP count
Sec1:6-Sec1:7
6 7
1. Repeatedly press the yellow MODE button until the
pedometer displays the current step count. (The
display will show a line underneath the word “STEP”
on the label.)
2. S1: Press and hold the yellow S1 (MODE) button for 2
seconds. The HOUR display will start to blink, showing
that you’ve entered SET mode.
3. S3: Press the S3 ▲ (MEMORY) button to increase the
HOUR display. Press the S3 ▼ (RESET) button to de
crease the HOUR display. Hold the button down to
change hours quickly. PM hours are displayed in
military time (1:00 PM is 13:00, 2:00 PM is 14:00, etc.).
4. S2: Press the yellow S2 (MODE) button to switch from
the HOUR display to the MINUTE display. The MINUTE
display will start to blink.
5. S3: Press the S3 ▲ (MEMORY) button to increase the
MINUTE display. Press the S3 ▼ (RESET) button to
decrease the MINUTE display. Hold the button down to
change minutes quickly.
6. S2: Press the yellow S2 (MODE) button again to enter
WEIGHT setting mode.