Chapter 8 Wireless LAN
EMG1302-R10A User’s Guide
85
8.9 Quality of Service (QoS) Screen
The QoS screen allows you to automatically give a service (such as VoIP and video) a priority level.
Click Configuration > Network > Wireless LAN > QoS. The following screen appears.
Figure 43 Configuration > Network > Wireless LAN > QoS
The following table describes the labels in this screen.
Intra-BSS Traffic A Basic Service Set (BSS) exists when all communications between wireless clients or
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is
enabled, wireless client A and B can access the wired network and communicate with
each other. When Intra-BSS is disabled, wireless client A and B can still access the
wired network but cannot communicate with each other.
Tx Power Set the Tx power of the EMG1302-R10A in this field. If there is a high density of APs in
an area, decrease the output power of the EMG1302-R10A to reduce interference with
other APs. Select one of the following 100%, 90%, 75%, 50%, 25% or 10%. See
the product specifications for more information on your EMG1302-R10A’s output power.
Apply Click Apply to save your changes back to the EMG1302-R10A.
Cancel Click Cancel to exit this screen without saving.
Table 26 Configuration > Network > Wireless LAN > Advanced (continued)
LABEL DESCRIPTION
Table 27 Configuration > Network > Wireless LAN > QoS
LABEL DESCRIPTION
WMM QoS Check Enable to have the EMG1302-R10A automatically give a service a priority level
according to the ToS value in the IP header of packets it sends. Check Disable to
disable the function.
WMM QoS (Wifi MultiMedia Quality of Service) gives high priority to voice and video,
which makes them run more smoothly.
Apply Click Apply to save your changes to the EMG1302-R10A.
Cancel Click Cancel to exit this screen without saving.
