Chapter 11 Quality of Service (QoS)
EMG1302-R10A User’s Guide
103
The following table describes the labels in this screen.
11.3 The Rule-based QoS Screen
Click Configuration > Network > QoS > Queue to open the screen as shown next.
Figure 56 Configuration > Network > QoS > Queue
Table 36 Configuration > Network > QoS > General
LABEL DESCRIPTION
QoS Select Enable or Disable to activate/disable the service.
Bandwidth of Upstream Enter the amount of upstream bandwidth for the WAN interfaces that you want
to allocate using QoS.
The recommendation is to set this speed to match the interfaces’ actual
transmission speed. For example, set the WAN interfaces’ speed to 100000 kbps
if your Internet connection has an upstream transmission speed of 100 Mbps.
You can set this number higher than the interfaces’ actual transmission speed.
The ZyXEL Device uses up to 95% of the DSL port’s actual upstream
transmission speed even if you set this number higher than the DSL port’s actual
transmission speed.
You can also set this number lower than the interfaces’ actual transmission
speed. This will cause the ZyXEL Device to not use some of the interfaces’
available bandwidth.
If you leave this field blank, the ZyXEL Device automatically sets this number to
be 95% of the WAN interfaces’ actual upstream transmission speed.
Bandwidth of Downstream Enter the amount of downstream bandwidth for the LAN interfaces (including
HPNA and WLAN) that you want to allocate using QoS.
The recommendation is to set this speed to match the WAN interfaces’ actual
transmission speed. For example, set the LAN managed downstream bandwidth
to 100000 kbps if you use a 100 Mbps wired Ethernet WAN connection.
You can also set this number lower than the WAN interfaces’ actual transmission
speed.
This will cause the ZyXEL Device to not use some of the interfaces’ available
bandwidth.
If you leave this field blank, the ZyXEL Device automatically sets this to the LAN
interfaces’ maximum supported connection speed.
Flexible Bandwidth
Management
Select Enable or Disable to activate/disable the service.
Apply Click Apply to save your changes back to the EMG1302-R10A.
Cancel Click Cancel to begin configuring this screen afresh.
