Chapter 7 WAN
EMG1302-R10A User’s Guide
59
The following table describes the labels in this screen.
Table 12 Configuration > WAN > Add New WAN Entry
LABEL DESCRIPTION
ISP Parameters for Internet Access
WAN Name Enter the name designation for this setting.
Note: Only the following parameters are available in Bridge mode: WAN name,
encapsulation and VID.
Encapsulation Select the encapsulation type: PPPoE, PPTP, IPoE, or Bridge.
VID (1~4094) Enter a VLAN identifier between 1 to 4094 (the 802.1Q tag specifies only a priority and
is referred to as a priority tag). In bridge mode, VID 1 (the default VLAN ID) is reserved
for a management VLAN.
IP Address Select Obtain an IP Address Automatically to have your ISP assign the parameters.
Select Static IP Address to enter a pre-defined IP Address, Subnet Mask, and
Gateway IP address.
MTU Size Enter the Maximum Transmission Unit (MTU) or the largest packet size per frame that
your EMG1302-R10A can receive and process.
DHCP Option
Enable DHCP Option
121
Select Enable DHCP Option 121 to enable the classless route option 121.
Enable DHCP Option
60
Select Enable DHCP Option 60 to enable and enter the device’s Vendor Class Identifier
(VCI).
DNS Server
First DNS Server
Second DNS Server
If you select Get automatically from ISP (Default) in the WAN IP Address
Assignment section, this field will automatically be set to From ISP. The field to the
right displays the (read-only) DNS server IP address that the ISP assigns.
If you select Use Fixed IP Address in the WAN IP Address Assignment section,
this field will automatically be set to User-Defined. Enter the DNS server's IP address
in the field to the right.
WAN MAC Address
WAN MAC Address The MAC address section allows users to configure the WAN port's MAC address by
either using the EMG1302-R10A’s MAC address, copying the MAC address from a
computer on your LAN or manually entering a MAC address.
Factory default Select Factory default to use the factory assigned default MAC Address.
Clone the
computer’s MAC
address
Select Clone the computer's MAC address and enter the IP address of the computer
on the LAN whose MAC you are cloning.
Set WAN MAC
Address
Select this option and enter the MAC address you want to use.
Apply Click Apply to save your changes back to the EMG1302-R10A.
Cancel Click Cancel to exit this screen without saving.
