Chapter 3 Hardware Panels
GS2210 Series User’s Guide
29
3.1.3 LED Mode (only available for GS2210-48HP)
After you push this button (see Section Figure 10 on page 26) to active PoE on the Switch, view the
LEDs to ensure proper functioning of the Switch and as an aid in troubleshooting (see Section 3.3
on page 30).
3.2 Rear Panel
The following figures show the rear panels of the Switch.
Figure 16 Rear Panel: GS2210-24
Figure 17 Rear Panel: GS2210-24HP
Figure 18 Rear Panel: GS2210-48
Figure 19 Rear Panel: GS2210-48HP
3.2.1 Console Port
For local management, you can use a computer with terminal emulation software configured to the
following parameters:
• VT100
• Terminal emulation
• 9600 bps
• No parity, 8 data bits, 1 stop bit
• No flow control
Connect the male 9-pin end of the console cable to the console port of the Switch. Connect the
female end to a serial port (COM1, COM2 or other COM port) of your computer.
3.2.2 Power Connector
Note: Make sure you are using the correct power source as shown on the panel.
