Chapter 23 Multicast
GS2210 Series User’s Guide
184
Figure 131 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
The following table describes the fields in the above screen.
Table 78 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
LABEL DESCRIPTION
Active
Select this option to enable MLD filtering on the Switch.
Port
This field displays the port number.
*
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use
this row first to set the common settings and then make adjustments on a port-
by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Group Limit
Select this option to limit the number of multicast groups this port is allowed to
join.
Max Group Num.
Enter the number of multicast groups this port is allowed to join. Once a port is
registered in the specified number of multicast groups, any new MLD Report
message is dropped on this port.
Filtering Profile
Select the name of the MLD filtering profile to use for this port. Otherwise, select
Default to prohibit the port from joining any multicast group.
You can create MLD filtering profiles in the Multicast > IPv6 Multicast > MLD
Snooping-proxy > Filtering > Filtering Profile screen.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel
Click Cancel to reset the fields to your previous configuration.
