FM/AM tuning
71 En
Internal Source
Operation
Use this feature to store the desired FM and AM stations manually.
You can also store up to 40 stations (A1 to E8: 8 preset station
numbers in each of the 5 preset station groups) manually.
1 Tune into the desired station.
See pages 68 and 69 for tuning instructions.
2 Press
J
MEMORY (or 0MEMORY).
The MEMORY indicator flashes in the front panel display for
approximately 10 seconds.
3 Press MPROGRAM (or 9A-E l / h) repeatedly to
select a preset station group (A to E) while the
MEMORY indicator is flashing.
The selected preset station group letter appears. Check that the
colon (:) appears in the front panel display.
4 Rotate MPROGRAM (or press 9PRESET/CH k / n
repeatedly) to select a preset station number (1 to 8)
while the MEMORY indicator is flashing.
• Rotate MPROGRAM rightward to select a higher preset
station number.
• Rotate MPROGRAM leftward to select a lower preset
station number.
5 Press
J
MEMORY (or 0MEMORY) while the
MEMORY indicator is flashing.
The station band and frequency appear in the front panel
display with the preset station group and number you have
selected. The MEMORY indicator disappears from the front
panel display.
• Any stored station data existing under a preset station number is
cleared when you store a new station under the same preset station
number.
• The reception mode (stereo or monaural) is stored along with the
station frequency.
You can exchange the assignments of two preset stations with each
other. The example below describes the procedure to exchange
preset station “E1” with “A5”.
1 Select preset station “E1” using
M
PROGRAM on
the front panel.
See “Selecting preset stations” on page 70.
2 Press and hold
L
EDIT for more than 3 seconds.
The MEMORY indicator flashes in the front panel display.
3 Select preset station “A5” using
M
PROGRAM.
The MEMORY indicator flash in the front panel display.
See “Selecting preset stations” on page 70.
4 Press
L
EDIT again.
“E1–A5” appears in the front panel display and the
assignments of the two preset stations are exchanged.
Before performing the following operations, set the operation mode
selector on the remote control to
F
SOURCE and then press
3TUNER.
Manual preset tuning
MEMORY
Flashes
MEMORY
A1:FM 88.9 MHz
Preset station group
FlashesColon (:)
MEMORY
A1:FM 88.9 MHz
Preset station number Flashes
Notes
Exchanging preset stations
A1:FM 88.9 MHz
The displayed station has been stored as A1.
MEMORY
E1:FM 88.9 MHz
EDIT
Flashes
MEMORY
A5:FM 88.9 MHz
EDIT
Flashes
A5:FM 88.9 MHz
E1-A5
