TL-WR840N 300Mbps Wireless N Router User Guide
- 5 -
1.4.2 The Rear Panel
Figure 1-2 Rear Panel sketch
The following parts are located on the rear panel (View from left to right).
¾ WIFI: This button is used to enable/disable the Router’s wireless function.
¾ WPS/RESET: This button is used for both WPS and Reset function. To use the WPS
function, press it for less than five seconds; to use the RESET function, press it for more
than five seconds.
z Used as RESET button:
There are two ways to reset to the Router's factory defaults:
1) Use the Factory Defaults function on System Tools -> Factory Defaults page in the
Router's Web-based Utility.
2) Use the WPS/RESET button: With the Router powered on, press and hold the
WPS/RESET button (more than 5 seconds) until the SYS LED becomes quick-flash from
slow-flash. Then release the button and wait the Router to reboot to its factory default
settings.
z Used as WPS button:
If you have client devices, such as wireless adapters, that support Wi-Fi Protected Setup,
then you can press this button to quickly establish a connection between the Router and
client devices and automatically configure wireless security for your wireless network.
¾ INTERNET: This INTERNET port is where you will connect the DSL/cable Modem.
¾ 4,3,2,1 (LAN): These ports (4,3,2,1) connect the Router to the local PC(s).
¾ ON/OFF: The switch for the power.
¾ POWER: The Power socket is where you will connect the power adapter. Please use the
power adapter provided with this TL-WR840N 300Mbps Wireless N Router.
