Introduction
The LXE MX7Battery Multi-charger is designedto simultaneously charge five Rechargeable Lithium Ion (Li-Ion)Battery
Packs. The time required for charging is dependent upon the battery pack temperature and conditions.
The battery chargershould be located in an area whereit:
l Is well ventilated.
l Is not in hightraffic areas.
l Locates or orients the AC cordso that it will not be stepped on, tripped overor subjectedto damageor stress.
l Has enough clearance to allow easy access to the power port on theback of the device.
l Is protected from rain, dust, direct sunlight or inclement weather.
This device is intended for indooruse only and requires an indoor AC power source. The charger is not approved for use in
Hazardous Locations.
This device cannot charge/recharge coin cell batteries sealed inside the mobile device, if any.
Quick Start
The following Quick Start instructions are abbreviated and intendedto give a brief overview of the process to be followed.
1. Assemble the power supply.
2. Connect the power supply to the charger.
3. Insert a battery into a charging bay.
4. When the battery is charging, the setup process is complete.
Note: Store the chargerand batteries when not in use in a cool, dry, protected place.
Please refer to the MX7 User Guidefor battery insert/remove instruction.
E-EQ-MX7CHGROG-E-ARC [ 1 ] MX7 Battery Multi-Charger/AnalyzerUser Guide
