Page 7 of 16 2342-222/2444A3WH8, 2342-422, 2342-522 Rev: 11/19/2013 8:18 AM
3) Press and hold the Mini Remote set button until it beeps again
LED will being blinking red
4) Press and hold the Responder’s Set button until it double-beeps (or LED blinks)
Mini remote will double-beep and its LED will stop blinking
5) Confirm that scene removal was successful by tapping the Mini Remote button on/off
Responder will not respond
6) If you wish to remove multiple responders from Mini Remote, repeat steps 1-5 for each additional
responder (or see Remove Mini Remote as a Controller of Multiple Responders
)
Using Mini Remote
8 Scene Toggle Mode (Default)
Each button will control all its scene members as follows:
Off or Dim
Turn scene on
Brighten until
Instant full-on
On or Bright
Turn scene off Dim until release Instant full-off
8 Scene Non-Toggle Mode (Always On)
Each button will control all its scene members as follows:
Turn scene on Brighten until release Instant full-on
4 Scene Mode
The On/Off button pairs each control all their scene members as follows:
On Right ^
Turn scene on Brighten until release Instant full-on
Off Left v
Turn scene off Dim until release Instant full-off
Note: Devices that respond to the scene trigger by turning off and non-dimmable devices will not respond
to dim and brighten commands.
LED Behavior
Mini Remote has a two-color LED (Green & Red) which momentarily indicates whether an on or an off is
being sent.
seconds)
One or more scene members did not acknowledge (note: scene members
may still have heard the scene command and adjusted their settings)
