Page 13 of 16 2342-222/2444A3WH8, 2342-422, 2342-522 Rev: 11/19/2013 8:18 AM
Yes, Embedded (shines red through case during charge)
869MHz (EU)
921MHz (AUS/NZ)
Retains all settings without power
Yes, all saved in Non-volatile EEPROM
2.6" H x 1.3" W x 0.39" D
Plastic Paddles over Contact Switches
Indoors, 32°F to 104°F, up to 85% relative humidity
3.7 VDC lithium polymer, rechargeable, non-replaceable
Battery life (between charges)
9-12 months under standard usage
Battery Re-charging cycles
Standard, Micro-USB, 5VDC
Troubleshooting
Mini Remote won’t add a
scene responder
Mini Remote may be out of range of
nearest dual-band INSTEON device
Try moving an access point or other dual-band
plug-in module closer to Mini Remote
The INSTEON signal may not be
getting to the “vicinity” of Responder
Make sure phases are bridged, add additional
INSTEON devices and/or move around existing
Large appliances, such as refrigerators
or air conditioners, may be producing
electrical noise on the power line
Install a power line noise filter (e.g. #1626-10) to
filter electrical noise and minimize signal attenuation
Other electrical devices, such as
computers, televisions, or power strips,
may be absorbing the INSTEON signal
Mini Remote will not turn a
Responder On (it may turn
it off)
Ramp Rate may be Extremely Slow
Or
Responder may be Linked at OFF
Re-link to Responder with fast Ramp Rate
