Page 11 of 16 2342-222/2444A3WH8, 2342-422, 2342-522 Rev: 11/19/2013 8:18 AM
Failure to add a scene responder
LED Behavior During Setup
Mini Remote has a two-color LED (Green & Red) which displays helpful information.
Add Responder Setup Mode, or
Remove Responder Setup Mode, or
Double-Blinking Green slowly
Multi-Add Responder Setup Mode, or
Double-Blinking Red slowly
Multi-Remove Responder Setup Mode, or
Keypad Configuration Setup Mode
Factory Reset
The factory reset procedure clears all settings from Mini Remote including INSTEON scenes.
1) If possible, unlink (remove) all scene responders prior to performing factory reset
2) Turn Mini Remote off (slide power switch to left)
3) Press and Hold Set Button
4) While continuing to hold the Set Button, turn Mini Remote back on (slide power switch to the right)
Mini Remote will beep and LED stays solid green
Mini Remote will emit a long beep
5) Continue to Hold Set Button until the long beep stops
LED turns solid red
6) Release Set Button
Mini Remote will double-beep and its LED will turn off
