Although normally not recommend-
ed, turn anticipation may be disabled
on the Setup 10 (SET 10) page by
pressing the B button and then
rotating the right inner knob to
change back and forth between
ENABLED (figure 4-36) and DIS-
ABLED (figure 4-37). If turn
anticipation is disabled, navigation is
provided all the way to the waypoint,
and waypoint alerting occurs approx-
imately 36 seconds prior to actually
reaching the waypoint.
4.2.3. VIEWING THE WAYPOINT PAGES FOR THE ACTIVE
FLIGHT PLAN WAYPOINTS
The waypoint pages for each of the waypoints in the active flight plan may
be easily displayed by selecting the Active (ACT) Waypoint page type.
When the ACT page type is first selected, the waypoint page for the active
waypoint will be displayed (figure 4-38). The location of the waypoint in
the flight plan (waypoint 1, waypoint
2, etc.) is annunciated with a number
to the left of the identifier. In addi-
tion, an arrow to the left of the
waypoint number designates the
active waypoint.
To view the waypoints in the flight plan that are not the active way-
point:
1. From the ACT page, pull the
right inner knob to the “out” posi-
tion and turn it to scan through
each of the waypoints in the
order they are contained in the
flight plan (figure 4-40).
2. Once the desired waypoint is
found, the right inner knob may
be pushed back to the “in” posi-
tion and rotated to display any of
the other waypoint pages for that
waypoint (figure 4-41).
3. Pulling the knob back out will allow further scanning of the waypoints
in the active flight plan.
KLN 94 Pilot’s Guide Chapter 4 Flight Plan Operation
4-11
Figure 4-36
Figure 4-37
Figure 4-38
Figure 4-40
Figure 4-41
