DCP200 Profile Controller & Recorder - Product Manual
Page 72 Profiler Option 51-52-25-150, Issue 1 – April 2009
Possible Recovery Methods:
Abort the profile and maintain the profile value from the time the power failed.
Abort the profile and use Controller Setpoint value.
Abort the profile with the Control outputs off.
Restart the profile again from the beginning.
Continue profile from the point it had reached when the power failed
Figure 44. End, Abort and Recovery Actions
Profile End Actions
Once a running profile ends, that profiles’ Segment End Type defines action taken by the
instrument. If a sequence of profiles has been completed, the End Segment Type of the last
profile will be carried out. The possible end actions are explained below.
Possible Profile End Actions:
At profile end, maintain the Final Setpoint value of the last segment.
At profile end, exit Profiler Mode and use the Controller Setpoint value.
At profile end, remain in Profiler Mode with the Control outputs off.
Figure 45. Profile End Action
Run
(Start-on SP)
Power On
= Control Off
Power Off Time
Controller SP
Run
(Start-on SP)
Normal Profile End
= Control Off
Last Profile SP
Controller SP
