29WPMAN0141 (8/31/01)
CD3554C
12
14
10
9
7
8
5
6
4
2
3
1
2
13
11
3
1. Front gauge wheel and
yoke assembly
2. 3/8 NC Locknut
3. 3/8 NC x 1” Carriage bolt
4. Left front arm assembly
5. 1 x 1/2” Pipe spacer
6. 1 x 3/4” Pipe spacer
7. 1 x 1” Pipe spacer
8. Compression spring
9. 1/2 x 1-9/16” x 10 GA Washer
10. 1/2” Lockwasher
11. 1/2 NC x 1-1/2” Hex head cap screw GR5
12. Right front arm assembly
13. 1/2 NC Flange locknut
14. 1/2 NC x 1-1/4” Hex head cap screw GR5
Figure 26. Front Caster Wheel Installation
Initial Filling of Gearbox
IMPORTANT
J Gearbox was not filled with oil at factory. It
must be serviced before operating. Failure to ser-
vice will result in damage to gearbox.
The gearbox was not filled at the factory. The initial fill
will take three pints of SAE 90W gear lube. Remove
the fill plug and pour in one quart of gear lube, wait
five minutes and add an additional pint. Allow an
additional five minutes for the lube to flow through the
bearings, then check to make sure half of the
horizontal gear shaft is covered. Replace the fill plug.
Pre-Delivery Check List
(DEALER RESPONSIBILITY)
Inspect the mower thoroughly after assembly to be
certain i t is set up properly before delivering it to the
customer. The following check list is a reminder of
points to inspect. Check off each item as it is found
satisfactory or after proper adjustment is made.
Check all bolts to be sure they are tight.
Check that all cotter pins are properly installed.
Check that all lubrication points with grease
fittings, driveline and spindles have been lubri-
cated.
Check that blades have been properly installed.
Check mower attitude and belt alignment.
Check that gearbox is properly serviced and
seals are not leaking.
Delivery Check L ist
(DEALER RESPONSIBILITY)
Show customer how to make adjustments.
Explain importance of lubrication to customer and
point out lubrication points on mower .
Point out safety features and options.
Present Operator’s Manual and ask customer to
become familiar with all sections.
Explain to customer that when mower is trans-
ported on a road or highway, safety devices
should be used for adequate warning to operators
of other vehicles.
(Rev. 6/6/2002)
