A SERVICE OF

logo

WPMAN0141 (8/31/01)16
BELT REPLACEMENT (Figure 9)
One of the major causes of belt failure is improper
installation. Before a new belt is installed, check
pulley shafts and bearings for wear. Check pulley
grooves for cleanliness. Make sure spindles turn
freely and without wobble. If grooves require clean-
ing, moisten a cloth with a non-flammable, non-toxic
degreasing agent or commercial detergent and water.
Avoid excessive force during installation. Do not use
tools to pry belt into pulley groove. Do not roll belt over
pulleys to install. This can cause hidden damage and
premature belt failure.
IMPORTANT
J Use care when installing or removing
belt from spring-loaded idler at step 5.
Springs store energy when extended and,
if released suddenly, can cause personal
injury.
G
1/8”
CD3546A
A
B
C
D
E
F
Figure 9. Belt Routing
1. Disconnect idler spring from deck lug.
2. Slide belt under drive pulley A and over idler arm.
Position belt around drive pulley A.
3. Loosen bolt holding belt guide G and swing it away
from pulley B. Route belt around pulley B, idler C
and pulley D as shown.
4. Make sure belt is on drive pulley A, route around
idler F, and connect idler spring to lug on deck.
5. Grasp belt between spindle pulley E, springloaded
idler F andspindle pulley D . Pull springloadedidler
with belt to obtain enough belt length to route it
over pulleyE. Make s urespring-loaded idlerpivots
freely with belt installed.
6. Adjust belt guide G to p rovide 1/16” to 1/8”
clearance from belt. Tighten bolt to 85 lbs.-ft.
BLADE SERVICING
Inspect blades for condition and proper installation
each time before operation. Replace any blade that is
bent, excessively nicked, worn or has any other
damage. Small nicks can be ground out when
sharpening.
WARNING
J Before performing any service or
ma int e na nc e , disc onne ct driveline from
tractor PTO.
J Keep all persons away from operator
control area while performing adjust-
ments, service or maintenance.
Blade Removal (Fig u re 10)
CD3558A
1
2
3
4
5
6
7
GM1060S SHOWN;
GM1072S SIMILAR
1. Spindle lock wrench
2. Pulley
3. Shoulder washer
4. Blade
5. 5/8 Standard flat washer
6. 5/8 x 1-3/4 x 14 GA Cup washers
7. 5/8 NC x 2 Hex head cap screw GR5 Nylok
Figure 10. Blade Installation
Remove belt shields.
Install spindle lock wrench (1) onto spindle pulley as
shown. Remove cap screw (7) which has RIGHT
HAND THREADS. Remove cup washers (6), washer
(5) and blade (4).
Shoulder washer (3) will not normally come off unless
intentionally removed.