Using the Document Camera 21
Adjusting the Image Position and Size
If you are displaying a
computer image using the
Video
or
S-Video
output
port, you can adjust its
position and size.
To adjust the image
position, use the
Position
arrow buttons on the remote
control.
To adjust the image size,
press and hold the
Main
button on the control panel.
Then use the right and/or down
Position
arrow buttons on the
remote control to enlarge the image. Use the up and/or left
Position
arrow buttons to reduce the image.
The document camera will remember the position and size. If the
signal frequency of the
RGB1
or
RGB2
port changes, however, you
may need to readjust the position.
Position arro
buttons
Remote control
note
You can’t adjust the position
or size of an image captured
with the overhead camera or
an image output through the
RGB video output port.
Control panel
Main
