A SERVICE OF

logo

List of Functions
63
f Others Menu
You can set the SNMPg. To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be
managed by a network administrator.
Sub Menu Function
SNMP trap IP
addressg 1/ SNMP
trap IP address 2
You can register up to two for the SNMP trap notification destination.
The IP address
g registered in "Trap IP Address 2" is used when the IP address in "Trap IP Address 1" cannot be accessed.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Gateway Setup For the priority gateway, select either wireless or wired.
AMX Device
Discoveryg
When "On" is set, and the projector is connected to a network, it can be detected using AMX Device Discovery. Set "Off" when the projector is not
connected to AMX controller or a network that enables AMX Device Discovery to detect the projector.