A SERVICE OF

logo

Open as PDF
next previous
30D-Link DAP-2690 User Manual
Section 3 - Configuration
User Limit (0 - 64):
Network Utilization:
Set the maximum amount of users that are allowed access (zero to 64 users).To use this feature, the Connection Limit
above must be enabled. For most users, a limit of 10 is recommended. The default setting is 20.
Set the maximum utilization of this access point for service. The DAP-2690 will not allow any new clients to associate
with the AP if the utilization exceeds the value the user specifies. Select a utilization percentage between 100%, 80%,
60%, 40%, 20%, or 0%. When this network utilization threshold is reached, the device will pause one minute to allow
network congestion to dissipate.
Multicast Rate:
Adjust the multicast packet data rate here. The multicast rate is supported in AP mode, (2.4 GHZ and 5 GHZ) and WDS
with AP mode, including Multi-SSIDs.