5
Frequently Asked Questions
What ports do systems management applications use?
The default port used by Server Administrator is 1311. These ports are configurable. For port information
of a particular component, see the User Guide of that respective component.
When I run virtual media on the DRAC controller over a
Wide Area Network (WAN) with low bandwidth and
latency, launching Systems Management Install directly
on the virtual media failed, what do I do?
Copy the web install package to the local system and then launch systems management Install.
Do I need to uninstall the Adaptec Fast Console
application installed on the system before installing the
Server Administrator Storage Management Service?
Yes, if you already have Adaptec Fast Console installed on the system, you must uninstall this application
before installing the Server Administrator Storage Management Service.
Red Hat Enterprise Linux or SUSE Linux Enterprise Server
After installing Server Administrator, I cannot log in.
Log out and then log in again to access the Server Administrator Command Line Interface (CLI).
I see the following message when I try to install Server Administrator on a
guest Linux operating system.
./srvadmin-install.sh: line 2295 : [: ==: unary operator expected.
When installing Systems Management components on a guest Linux operating system, the warning
message may be displayed. However, the installation continues and completes without any loss of
functionality.
45
