A SERVICE OF

logo

3.
Unplug the
electrical
connector.
4.
Turn the bulb
to
the left and
remove
it.
5.
Put the new bulb
in
the lens assembly and
turn
it
to
the right
until
it
is
tight.
6.
Plug
in
the electrical connector.
7.
Put the headlamp lens assembly back into the vehicle. Install and
tighten the two screws.
Front ParkingYTurn Signal Lamps with Sealed Beam
Headlamps
2.
1.
Remove the
two
screws
at
the
inside edge of the
parkingkurn
signal lamp
assembly.
Remove the lamp assembly by swinging
it
out
from the inside edge and
sliding
it
out at the outside edge.
6-48